TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
E0568 Unexpected Left
1. Perform initial pressure tests (WP
Motor Forward Speed
0031) before performing any
Detected
hydraulic tests, and adjustments.
E0569 Unexpected Left
2. Turn ignition switch and battery
Motor Reverse Speed
disconnect switch to OFF position
Detected
(TM 5-2410-240-10).
E0570 Unexpected Right
3. Turn battery disconnect switch
Motor Forward Speed
and ignition switch to ON position
Detected
(TM 5-2410-240-10).
E0571 Unexpected Right
Motor Reverse Speed
Detected
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Diagnostic Codes are Active - Refer
for active diagnostic codes (WP
first.
Diagnostic Codes are Not Active-
Proceed with step 5.
5. Verify that symptom is active.
Symptom Not Active - Operate
machine and document when condi-
tion occurs.
Symptom Active - Perform Final
E0577 Engine Ramp Rate
Machine ECM logs event and a warn- Allow engine and hydraulic tempera-
Limited Due to Cold Hydrau- ing will display on control panel.
ture to warm up before operating
lic Oil
machine under load.
E0679 Idle Elevated in Order
Water temperature regulator is not
Replace water temperature regulator
to Increase Engine Coolant
operating properly.
(WP 0082). Verify proper operation of
Temperature
machine (TM 5-2410-240-10).
E0695 Unexpected Motor
1. Turn ignition switch and battery
Speed Detection Disabled
disconnect switch to OFF position
(TM 5-2410-240-10).
2. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Diagnostic Codes are Active - Refer
for active diagnostic codes (WP
first.
Diagnostic Codes are Not Active -
Proceed to step 4.