CLEANING AND INSPECTION
Clean and inspect all components IAW Mechanical General Maintenance Instructions (WP 0282).
END OF TASK
N OT E
If replacement fuel injector is installed, record fuel injector code prior to installation.
1. If a replacement fuel injector is installed, the correct injector trim file must be programmed into electronic
control module (ECM). Record fuel injector code (Figure 6, Item 1) to obtain injector trim file (WP 0026).
Figure 6. Fuel Injector Code.
C AU T I O N
Ensure that O-ring and sealing washer are installed correctly, are clean, and are not
Do not lubricate O-ring.
Failure to follow caution, may cause engine damage.
N OT E
Evacuate as much fuel as possible from cylinder prior to installing fuel injector.
2. Install new O-ring (Figure 5, Item 3) and sealing washer (Figure 5, Item 1) on fuel injector (Figure 5, Item 2).