LEFT DRIVE LOOP HOSE REMOVAL
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap or plug all hydraulic hose ends and fittings during removal to protect against
contamination. Failure to follow this caution may cause damage to equipment.
N OT E
Hydraulic hoses, clamps, and fittings are all removed using the same general method.
This procedure covers removal of one hydraulic hose assembly from machine.
Tag and mark hose and fitting to aid installation.
Use a container to catch any fluid that may drain from hose or system. Dispose of fluid
IAW local policy and ordinances. Ensure all spills are cleaned up.
1. Remove bolt (Figure 4, Item 5), washer (Figure 4, Item 4), and clamp (Figure 4, Item 7) from bracket (Figure 4,
2. Remove clamp (Figure 4, Item 7) from tubes (Figure 4, Item 3).
3. Loosen two fittings (Figure 4, Items 2 and 9).
4. Disconnect hose (Figure 4, Item 10) from tube (Figure 4, Item 3).
5. Disconnect tube (Figure 4, Item 3) from connector (Figure 4, Item 1).
6. Remove O-ring (Figure 4, Item 8) from tube (Figure 4, Item 3). Discard O-ring.