5. Disengage bale wires (Figure 3, Item 4) from lugs (Figure 3, Item 5).
6. Remove bulb (Figure 3, Item 2) from lamp assembly (Figure 3, Item 1).
Figure 3. Bulb Assembly Removal.
END OF TASK
C AU T I O N
Do not touch the glass surface of a halogen bulb with bare fingers, as the surface will be
exposed to the salts and oils in the hand. If glass is touched, it must be cleaned
immediately with a gentle solvent such as alcohol. Failure to follow this caution will result
in early bulb failure.
1. Install bulb (Figure 3, Item 2) into lamp assembly (Figure 3, Item 1), feeding the white wire under the plastic
retainer (Figure 3, Item 3).
2. Secure bulb in place by engaging bale wires (Figure 3, Item 4) under lugs (Figure 3, Item 5).