TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1404-5 Transmission Sole-
10. Turn ignition switch and battery
noid Valve #4 Current
disconnect switch to OFF position
Below Normal - Contin-
(TM 5-2410-241-10).
ued
11. Remove jumper wire between pins
valve #4 connector P-C6 (WP
12. Remove left platform access panel
(WP 0207).
13. Disconnect steering control har-
Figure 34) from platform harness
Figure 33).
14. Disconnect powertrain ECM con-
from powertrain ECM.
1.
If continuity is found, proceed to
0296), test for continuity between
step 16.
pin 49 on powertrain ECM connec- 2.
steering control harness (WP
pin 25 on steering control harness
0178). Ensure all harness connec-
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
1.
If continuity is found, proceed to
0296), test for continuity between
step 17.
pin 50 on powertrain ECM connec- 2.
steering control harness (WP
pin 31 on steering control harness
0178). Ensure all harness connec-
tors are reconnected. Verify cor-
Figure 34).
rect operation of machine (TM 5-
2410-241-10).
17. Remove rear floor plate (WP
0231).
18. Disconnect platform harness con-
Figure 53) from transmission
jumper harness connector MP-C2
0020-206