4TM5-2410-234-34P (6) When the item is not used with all serial numbers of the same model, the effective serial numbers are shown on the last line(s) of the description (before UOC). Not applicable. (7) The usable on code, when applicable (see paragraph 5, Special information). (8) In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for each special tool, special TMDE and other special support equipment. When density of equipments supported exceeds density spread indicated in the basis of issue, the total authorization is increased proportionately. (9) The statement ’END OF FIGURE" appears just below the last item description in Column 6 for a given figure in both Section II and Section III. f. QTY (Column (7)). The QTY (quantity per figure column) indicates the quantity of the item used in the breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group or an assembly. A "V" appearing in this column in lieu of a quantity indicates that the quantity is variable and the quantity may vary from application to application. 4. Explanation of Columns (Section IV). a. NATIONAL STOCK NUMBER (NSN) INDEX (1) STOCK NUMBER column. This column lists the NSN by National item identification number (NIIN) sequence. The NIIN consists of the last nine NSN digits of the NSN (i e, 5305-01-674-1467) When NIIN using this column to locate an item, ignore the first 4 digits of the NSN however, the complete NSN should be used when ordering items by stock number. (2) FIG. Column. This column lists the number of the figure where the item is identified, located. The figures are in numerical order in Section II and Section Ill. (3) ITEM column The item number identifies the item associated with the figure listed in the adjacent FIG. column. This item is also Identified by the NSN listed on the same line. b. PART NUMBER INDEX Part numbers in this index are listed by part number in ascending alphanumeric sequence (i e, vertical arrangement of letter and number combination which places the first letter or digit of each group in order A through Z, SECTION I followed by the numbers 0 through 9 and each following letter or digit in like order). (1) CAGEC column The Commercial And Government Entity (CAGE) Code (C) Is a 5 digit alphanumeric code used to Identify the manufacturer, distributor or Government agency, etc., that supplies the item. (2) PART NUMBER column Indicates the primary number used by the manufacturer (individual, firm, corporation or Government activity), which controls the design and characteristics of the Item by means of Its engineering drawings, specifications standards, and Inspection requirements to Identify an item or range of Items. (3) STOCK NUMBER column This column lists the NSN for the associated part number and manufacturer Identified In the PART NUMBER and CAGEC columns to the left. (4) FIG. column. This column lists the number of the figure where the item is identified located in Section II and III. 5. Special Information. Use the following subparagraphs as applicable: a. USABLE ON CODE: Code Used On END ITEM APPLICATIONS T24 MODEL D8K-8A-58 (CCE) T25 MODEL D8K-8S-8 (CCE) b. ASSEMBLY INSTRUCTIONS. Detailed assembly instructions for items source coded to be assembled from component spare/repair parts are found in TM 5-2410-233-20 and TM 5-2410-233-34. Items that make up the assembly are listed immediately following the assembly item entry or reference is made to an applicable figure. c. KITS. Line item entries for repair parts kits appear in group 9401 in Section II. d. INDEX NUMBERS. Items which have the word BULK in the figure column will have an index number shown in the item number column. This index number is a cross-reference between the National Stock Number/Part Number Index and the bulk material list in Section II.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business