8. Remove two bolts (Figure 6, Item 4), washers (Figure 6, Item 3), nuts (Figure 6, Item 1), shim pack (Figure 6,
Item 2), and half-yoke (Figure 6, Item 5) from push arm (Figure 6, Item 6). Repeat step 8 for other side.
Figure 6. Push Arm Yoke.
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause injury or death to personnel.
N OT E
Stabilizer bar weighs 207 lb (94 kg).