5. Fully extend lift cylinders (Figure 21, Item 6).
6. Install half-yoke (Figure 21, Item 3), shim pack (Figure 21, Item 2), four bolts (Figure 21, Item 4), and nuts
(Figure 21, Item 1) on blade assembly (Figure 21, Item 5). Repeat for other side.
Figure 21. Lift Cylinder Yoke.
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may cause injury or death to personnel.
N OT E
Stabilizer bar weighs 207 lb (94 kg).