TM 5-2410-240-10
0002
LOCATION AND DESCRIPTION OF MAJOR COMPONENTS CONTINUED
KEY
COMPONENT
DESCRIPTION
1
Blade
Used for earth moving.
2
Grab Handle
Provides hand-hold when mounting/dismounting machine.
3
Exhaust Pipe
Directs exhaust fumes away from machine.
4
Primary Exit
Door on left side of machine provides primary entry/exit point
for operator.
5
Fuel Tank Filler Neck and Cap
Provides means to fill and seal fuel tank.
6
Arctic Heater Battery Case
Houses batteries for arctic heater, if equipped.
7
Left Rear Access Door
Provides access to cab fresh-air filter, hydraulic oil filler cap,
and fuel shutoff valve.
8
Hydraulic Oil Level Sight Gauge
Provides means to check hydraulic oil level.
9
Ripper
Used for breaking up material.
10
Pivot Shaft Oil Level Check Plug
Provides means to check and fill pivot shaft oil level.
11
Track Adjustment Valve Cover
Provides access to track adjustment valve.
12
Blade Lift Cylinder
Raises and lowers dozer blade.
13
Left Front Access Door
Provides access to ether starting aid cylinder, fuel system
priming pump, primary and secondary air filter elements,
engine oil level gauge, engine oil fill cap, engine coolant
reservoir, fuel/water separator, fuel shutoff valve, and 24V
slave receptacle.
14
Blade Angle Cylinder
Angles dozer blade left or right.
15
Step
Provides safe means to climb on and off machine.
16
End Bit
Replaceable outer edges of dozer blade.
17
Cutting Edge
Replaceable lower edge of dozer blade.
0002-3
