TM 5-2410-240-10
0005
WINCH OPERATION CONTINUED
Drive Away Mode
0005
DRIVE AWAY mode allows operator to drive machine away from a load while winch cable is attached to load.
When drive away switch is pushed, winch brake is disabled; winch clutch remains engaged providing a controlled
release of cable. Drive machine away from load to reel out cable. Maximum ground speed of machine while in
drive away mode should be 2.6 mph (4.2 km/h). Switch remains in drive away mode until pushed again or another
winch function is activated.
END OF TASK
RIPPER OPERATION
0005
C AU T I O N
DO NOT operate machine in reverse while ripper is in a lowered position. Damage to
equipment will occur.
N OT E
Ripper control lever will return to HOLD position when released. Ripper will remain in
position when control lever is released.
1. Adjust shank in or out according to conditions required for operation (WP 0004).
2. Lower ripper to desired depth (WP 0004).
3. Drive machine in forward direction to break up material.
4. Raise ripper at end of path (WP 0004).
5. Continue ripping operation, adjusting ripper depth as work progresses, until all material is suitably broken up.
END OF TASK
END OF WORK PACKAGE
0005-16