TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1703-06 Proportional Sole-
12. Using digital multimeter (WP
Continuity - Proceed to step 13.
noid Valve (Forward Left
0283), test for continuity between
No Continuity - Replace engine wir-
Drive Pump) Current Above
pin 17 on engine harness to plat-
ing harness assembly (WP 0046).
Normal - Continued
form harness connector EN-C15
Ensure all harness connectors are
(WP 0018, Figure 132) and pin 4
reconnected. Verify proper operation
on engine harness to platform
of machine (TM 5-2410-240-10).
harness connector EN-C21
(WP 0018, Figure 137).
13. Using digital multimeter (WP
No Continuity - Proceed to step 14.
0283), test for continuity between
Continuity - Replace engine wiring
pin 19 on engine harness to plat-
harness assembly (WP 0046). Ensure
form harness connector EN-C15
all harness connectors are recon-
(WP 0018, Figure 132) and all
nected. Verify proper operation of
other pins on engine harness to
machine (TM 5-2410-240-10).
platform harness connector
EN-C15 (WP 0018, Figure 132).
14. Disconnect platform harness
ECM J1 connector PL-C4 (WP
0018, Figure 217) from machine
ECM (WP 0147, WP 0149).
15. Disconnect platform harness
ECM J2 connector PL-C5 (WP
0018, Figure 218) from machine
ECM (WP 0147, WP 0149).
16. Using digital multimeter (WP
Continuity - Proceed to step 17.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 48 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 19 on plat-
reconnected. Verify proper operation
form harness to engine harness
of machine (TM 5-2410-240-10).
connector PL-C15 (WP 0018,
Figure 225).
17. Using digital multimeter (WP
Continuity - Proceed to step 18.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 50 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 17 on plat-
reconnected. Verify proper operation
form harness to engine harness
of machine (TM 5-2410-240-10).
connector PL-C15 (WP 0018,
Figure 225).
18. Using digital multimeter (WP
No Continuity - Proceed to step 19.
0283), test for continuity between
Continuity - Replace platform wiring
pin 48 on platform harness ECM
harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and all other pins on
reconnected. Verify proper operation
platform harness ECM J1 connec-
of machine (TM 5-2410-240-10).
tor PL-C4 (WP 0018, Figure 217).
0020-87