TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1700-08 Joystick Position Sensor
22. Using digital multimeter, test
No Continuity - Replace platform
(Left/Right) Abnormal Frequency,
for continuity (WP 0283)
wiring harness (WP 0150,
Pulse Width, or Period Continued
between harness connector
WP 0155). Ensure all harness con-
PL-C5 (WP 0018, Figure 218)
nectors are reconnected. Verify
terminal 25 and harness con-
proper operation of machine (TM
nector PL-C1 (WP 0018, Fig-
5-2410-240-10).
ure 214) terminal 43.
Continuity - Proceed to step 23.
23. Using digital multimeter, test
No Continuity - Replace machine
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 25 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform wir-
ing harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
1700-13 Joystick Position Sensor
Joystick left/right position sensor
Perform Operator Control Calibra-
(Left/Right) Out of Calibration
requires calibration.
tions (Hystat) (WP 0033). If diag-
nostic code returns, replace
machine ECM (WP 0147,
WP 0149).
N OT E
1870-03 Blade Control Handle
Thumb Rocker Position Sensor Volt-
Always inspect harness connectors that are involved in circuit.
age Above Normal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove right joystick cover
(WP 0238).
