TM 5-2410-240-23-3
0259
REMOVAL
000259
WARN I N G
DO NOT disconnect or remove any hydraulic system hoses, tubes, or fittings unless
engine is shut down and hydraulic system pressure has been relieved. Tighten all
connections before applying pressure. Escaping hydraulic fluid under pressure can
penetrate skin.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before removing
any hydraulic fitting.
Wear protective eye covering and gloves.
Lubricating/hydraulic oils used in perfomance of maintenance can be very slippery.
r
Immediately wipe up any spills.
Failure to follow these warnings may result in injury or death to personnel.
C AU T I O N
Cap or plug all hydraulic and lubrication hose ends and fittings during removal to protect
against contamination. Failure to follow this caution may result in damage to equipment.
N OT E
This procedure covers removal of hydraulic and lubrication hoses from left side of
machine. Follow the same procedure when removing hydraulic and lubrication hoses from
right side of machine.
Tag and mark hydraulic and lubrication hose and fittings and note hose routing to aid
s
installation.
Use a container to catch any fluid that ma drain from hydraulic system. Dispose of fluid
y
IAW local policy and ordinances. Ensure all spills are cleaned up.
1. Remove four bolts (Figure 1, Item 1), washers (Figure 1, Item 2), five clamps (Figure 1, Item 14), and four
grommets (Figure 1, Item 13) from three hydraulic hoses (Figure 1, Item 3).
2. Loosen three fittings (Figure 1, Item 4) and disconnect hydraulic hoses (Figure 1, Item 3) from connectors
(Figure 1, Item 6).
3. Remove three O-rings (Figure 1, Item 5) from connectors (Figure 1, Item 6). Discard O-rings.
4. Loosen three fittings (Figure 1, Item 9) and disconnect hydraulic hoses (Figure 1, Item 3) from connectors
(Figure 1, Item 7).
5. Remove three O-rings (Figure 1, Item 8) from connectors (Figure 1, Item 7). Discard O-rings.
6. Remove three hydraulic hoses (Figure 1, Item 3) from machine.
7. Loosen two fittings (Figure 1, Item 11) and disconnect lubrication hoses (Figure 1, Item 12) from connectors
(Figure 1, Item 10).
8. Remove two lubrication hoses (Figure 1, Item 12) from machine.
0259-2
