TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1704-06 Proportional Sole-
5. Turn ignition switch and battery
noid Valve (Reverse Left
disconnect switch to OFF position
Drive Pump) Current Above
(TM 5-2410-240-10).
Normal - Continued
6. Disconnect pump harness to
engine harness connector PH-C1
(WP 0018, Figure 205) from
engine harness to platform har-
ness connector EN-C21 (WP
0018, Figure 137).
7. Using digital multimeter (WP
Continuity - Proceed to step 8.
0283), test for continuity between
No Continuity - Replace pump har-
pin 1 on pump harness to engine
ness (WP 0046). Ensure all harness
harness connector PH-C1 (WP
connectors are reconnected. Verify
0018, Figure 205) and pin 1 on
proper operation of machine (TM 5-
pump harness LH reverse pump
2410-240-10).
solenoid connector PH-C6 (WP
0018, Figure 210).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace pump har-
pin 4 on pump harness to engine
ness (WP 0046). Ensure all harness
harness connector PH-C1 (WP
connectors are reconnected. Verify
0018, Figure 205) and pin 2 on
proper operation of machine (TM 5-
pump harness LH reverse pump
2410-240-10).
solenoid connector PH-C6 (WP
0018, Figure 210).
9. Using digital multimeter (WP
No Continuity - Proceed to step 10.
0283), test for continuity between
Continuity - Replace pump harness
pin 1 on pump harness to engine
(WP 0046). Ensure all harness con-
harness connector PH-C1 (WP
nectors are reconnected. Verify
0018, Figure 205) and all other
proper operation of machine (TM 5-
pins on pump harness to engine
2410-240-10).
harness connector PH-C1 (WP
0018, Figure 205).
10. Disconnect platform harness to
engine harness connector PL-
C15 (WP 0018, Figure 225) from
engine harness to platform har-
ness connector EN-C15 (WP
0018, Figure 132).
11. Using digital multimeter (WP
Continuity - Proceed to step 12.
0283), test for continuity between
No Continuity - Replace engine wir-
pin 16 on engine harness to plat-
ing harness assembly (WP 0046).
form harness connector EN-C15
Ensure all harness connectors are
(WP 0018, Figure 132) and pin 1
reconnected. Verify proper operation
on engine harness to platform
of machine (TM 5-2410-240-10).
harness connector EN-C21 (WP
0018, Figure 137).
0020-95