TM 5-2410-240-23-1
0020
Table 2. Powertrain and Chassis Troubleshooting with Codes - Continued.
CID FMI CODE
Test or Inspection
Corrective Action
1705-03 Proportional Sole-
7. Disconnect platform harness to
noid Valve (Forward Right
engine harness connector PL-
Drive Pump) Voltage Above
C15 (WP 0018, Figure 225) from
Normal - Continued
engine harness to platform har-
ness connector EN-C15 (WP
0018, Figure 132).
8. Using digital multimeter (WP
Continuity - Proceed to step 9.
0283), test for continuity between
No Continuity - Replace engine wir-
pin 20 on engine harness to plat-
ing harness assembly (WP 0046).
form harness connector EN-C15
Ensure all harness connectors are
(WP 0018, Figure 132) and pin 3
reconnected. Verify proper operation
on engine harness to platform
of machine (TM 5-2410-240-10).
harness connector EN-C21
(WP 0018, Figure 137).
9. Using digital multimeter (WP
No Continuity - Proceed to step 10.
0283), test for continuity between
Continuity - Replace engine wiring
pin 20 on engine harness to plat-
harness assembly (WP 0046). Ensure
form harness connector EN-C15
all harness connectors are recon-
(WP 0018, Figure 132) and all
nected. Verify proper operation of
other pins on engine harness to
machine (TM 5-2410-240-10).
platform harness connector
EN-C15 (WP 0018, Figure 132).
10. Disconnect platform harness
ECM J1 connector PL-C4
(WP 0018, Figure 217) from
machine ECM (WP 0147, WP
0149).
11. Disconnect platform harness
ECM J2 connector PL-C5
(WP 0018, Figure 218) from
machine ECM (WP 0147, WP
0149).
12. Using digital multimeter (WP
Continuity - Proceed to step 13.
0283), test for continuity between
No Continuity - Replace platform wir-
pin 51 on platform harness ECM
ing harness (WP 0150, WP 0155).
J1 connector PL-C4 (WP 0018,
Ensure all harness connectors are
Figure 217) and pin 20 on plat-
reconnected. Verify proper operation
form harness to engine harness
of machine (TM 5-2410-240-10).
connector PL-C15 (WP 0018, Fig-
ure 225).
13. Using digital multimeter
No Continuity - Proceed to step 14.
(WP 0283), test for continuity
Continuity - Replace platform wiring
between pin 51 on platform har-
harness (WP 0150, WP 0155).
ness ECM J1 connector PL-C4
Ensure all harness connectors are
(WP 0018, Figure 217) and all
reconnected. Verify proper operation
other pins on platform harness
of machine (TM 5-2410-240-10).
ECM J1 connector PL-C4 (WP
0018, Figure 217).
0020-99
