TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2500-04 Powertrain Speed Range
12. Using digital multimeter, test
No Continuity - Proceed to step
Control Position Sensor Voltage
for continuity (WP 0283)
13.
Below Normal - Continued
between harness connector
Continuity - Replace seat harness
CA-C1 (WP 0018, Figure 69)
(WP 0236). Ensure all harness
terminal 4 and all other termi-
connectors are reconnected. Verify
nals in harness connector CA-
proper operation of machine (TM
C1 (WP 0018, Figure 69).
5-2410-240-10).
13. Disconnect harness connec-
tor C-C12 (WP 0018, Figure
22) from PL-C1 (WP 0018,
Figure 214).
14. Using digital multimeter, test
No Continuity - Replace lower
for continuity (WP 0283) (WP
cab harness (WP 0228). Ensure all
0283) between harness con-
harness connectors are recon-
nector C-C12 (WP 0018, Fig-
nected. Verify proper operation of
ure 22) terminal 45 and
machine (TM 5-2410-240-10).
harness connector C-C24 (WP
Continuity - Proceed to step 15.
0018, Figure 26) terminal 2.
15. Using digital multimeter, test
No Continuity - Replace lower
for continuity (WP 0283)
cab harness (WP 0228). Ensure all
between harness connector
harness connectors are recon-
C-C12 (WP 0018, Figure 22)
nected. Verify proper operation of
terminal 44 and harness con-
machine (TM 5-2410-240-10).
nector C-C24 (WP 0018, Fig-
Continuity - Proceed to step 16.
ure 26) terminal 9.
16. Using digital multimeter, test
No Continuity - Replace lower
for continuity (WP 0283)
cab harness (WP 0228). Ensure all
between harness connector
harness connectors are recon-
C-C12 (WP 0018, Figure 22)
nected. Verify proper operation of
terminal 40 and harness con-
machine (TM 5-2410-240-10).
nector C-C24 (WP 0018, Fig-
Continuity - Proceed to step 17.
ure 26) terminal 4.
17. Using digital multimeter, test
No Continuity - Proceed to
for continuity (WP 0283)
step 18.
between harness connector
Continuity - Replace lower cab
C-C12 (WP 0018, Figure 22)
harness (WP 0228). Ensure all
terminal 40 and all other termi-
harness connectors are recon-
nals in harness connector C-
nected. Verify proper operation of
C12 (WP 0018, Figure 22).
machine (TM 5-2410-240-10).
18. Disconnect harness connec-
tor PL-C4 (WP 0018, Figure
217) from equipment ECM J1.
19. Disconnect harness connec-
tor PL-C5 (WP 0018, Figure
218) from equipment ECM J2.
0021-271
