TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2500-08 Powertrain Speed Range
22. Using digital multimeter, test
No Continuity - Replace platform
Control Position Sensor Abnormal
for continuity (WP 0283)
wiring harness (WP 0150, WP
Frequency, Pulse Width, or Period
between harness connector
0155). Ensure all harness connec-
Continued
PL-C5 (WP 0018, Figure 218)
tors are reconnected. Verify proper
terminal 51 and harness con-
operation of machine (TM 5-2410-
nector PL-C1 (WP 0018, Fig-
240-10).
ure 214) terminal 40.
Continuity - Proceed to step 23.
23. Using digital multimeter, test
No Continuity - Replace machine
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 51 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform wir-
ing harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
Perform Operator Control Calibra-
Powertrain speed range control
2500-13 Powertrain Speed Range
position sensor signal requires cal- tions (Hystat) (WP 0033). If diag-
Control Position Sensor Out Of Cali-
nostic code returns, replace
ibration.
bration
machine ECM (WP 0147,
WP 0150).
N OT E
2532-03 Operator Gear Ratio Set/
Recall Switch Position Voltage
Always inspect harness connectors that are involved in circuit.
Above Normal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C6 (WP 0018,
Figure 72) from transmission
control handle (WP 0018,
Figure 77).