TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2532-03 Operator Gear Ratio Set/
22. Using digital multimeter, test
No Continuity - Proceed to
Recall Switch Position Voltage
for continuity (WP 0283)
step 23.
Above Normal - Continued
between harness connector
Continuity - Replace platform wir-
PL-C4 (WP 0018, Figure 217)
ing harness (WP 0150, WP 0155).
terminal 42 and all other termi-
Ensure all harness connectors are
nals in harness connector PL-
reconnected. Verify proper opera-
C4 (WP 0018, Figure 217).
tion of machine (TM 5-2410-240-
10).
23. Using digital multimeter, test
No Continuity - Replace machine
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between harness connector
Ensure all harness connectors are
PL-C4 (WP 0018, Figure 217)
reconnected. Verify proper opera-
terminal 41 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C4 (WP 0018, Figure 217).
Continuity - Replace platform wir-
ing harness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
2532-04 Operator Gear Ratio Set/
Recall Switch Position Voltage
Always inspect harness connectors that are involved in circuit.
Below Normal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C6 (WP 0018, Figure
72) from transmission control
handle (WP 0018, Figure 77).