TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
2500-03 Powertrain Speed Range
Control Position Sensor Voltage
Always inspect harness connectors that are involved in circuit.
Above Normal
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
2. Remove left joystick cover
(WP 0237).
3. Disconnect harness connec-
tor CA-C6 (WP 0018, Figure
72) from transmission control
handle.
4. Turn the ignition switch and
battery disconnect switch to
the ON position (TM 5-2410-
240-10).
5. Using digital multimeter, mea-
Voltage Less Than Specified
sure voltage (WP 0283) of
Range - Proceed to step 7.
10-volt supply circuit between
Voltage Within Specified Range
harness connector CA-C6
- Proceed to step 6.
(WP 0018, Figure 72) terminal
1 and 2.
There should be approximately
10 volts 0.5 volts.
6. Using digital multimeter, mea-
Voltage Less Than Specified
sure for voltage (WP 0283)
Range - Proceed to step 7.
between harness connector
Voltage Within Specified Range
CA-C6 (WP 0018, Figure 72)
- Replace left joystick control (WP
terminal 2 and 3.
0239). Ensure all harness connec-
There should be approximately
tors are reconnected. Verify proper
5 volts 0.5 volts.
operation of machine (TM 5-2410-
240-10).
7. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
