TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2438-04 Winch Free Spool Switch
14. Using digital multimeter, test
No Continuity - Replace machine
Voltage Below Normal - Continued
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between PL-C5 (WP 0018,
Ensure all harness connectors are
Figure 218) equipment ECM
reconnected. Verify proper opera-
J2 terminal 37 and all other
tion of machine (TM 5-2410-240-
terminals in harness connec-
10).
tor PL-C5 (WP 0018, Figure
Continuity - Replace platform har-
218).
ness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
N OT E
2481-03 Winch Drive Away Switch
Voltage Above Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor C-C52 (WP 0018, Figure
39) from winch drive-away
switch (WP 0018, Figure 59).