TM 5-2410-240-23-1
0021
Table 2. Cab Troubleshooting With Codes. - Continued.
0021
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2305-08 Brake/Decelerator Pedal
25. Using digital multimeter, test
No Continuity - Replace platform
Position Sensor Abnormal Fre-
for continuity (WP 0283)
wiring harness (WP 0150,
quency, Pulse Width Or Period -
between harness connector
WP 0155). Ensure all harness con-
Continued
PL-C5 (WP 0018, Figure 218)
nectors are reconnected. Verify
terminal 24 and harness con-
proper operation of machine (TM
nector PL-C1 (WP 0018, Fig-
5-2410-240-10).
ure 214) terminal 35.
Continuity - Proceed to step 26.
26. Using digital multimeter, test
No Continuity - Replace machine
for continuity (WP 0283)
ECM (WP 0147, WP 0149).
between harness connector
Ensure all harness connectors are
PL-C5 (WP 0018, Figure 218)
reconnected. Verify proper opera-
terminal 24 and all other termi-
tion of machine (TM 5-2410-240-
nals in harness connector PL-
10).
C5 (WP 0018, Figure 218).
Continuity - Replace platform har-
ness (WP 0150, WP 0155).
Ensure all harness connectors are
reconnected. Verify proper opera-
tion of machine (TM 5-2410-240-
10).
Perform Operator Control Calibra-
Brake/decelerator pedal position
2305-13 Brake/Decelerator Pedal
sensor requires calibration.
tions (Hystat) (WP 0033). If diag-
Position Sensor Out Of Calibration
nostic code returns, replace
machine ECM (WP 0147, WP
0150).
N OT E
2438-03 Winch Free Spool Switch
Voltage Above Normal
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Perform this test only if condition is active.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Disconnect harness connec-
tor C-C51 (WP 0018, Figure
38) from free-spool switch
(WP 0018, Figure 58).
