TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2482-04 Winch Drive Away
7. Using digital multimeter (WP
No Continuity on Test Point - Pro-
Solenoid Voltage Below Nor-
0283), test for continuity between
ceed to Test Step 3.
mal - Continued
PL-C2 terminal 59 (WP 0018, Fig-
Continuity on Test Point - Replace
ure 215) and ground.
platform wiring harness (WP 0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 8.
8. Using MSD (WP 0016), select
Code 2482-04 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2482-04 is not active.
Code 2482-04 Not Active - Trouble-
shooting complete.
Test Step 3. Test J813-BK Drive-
Away Solenoid Return Circuit for
Short to Other Circuits in WInch
Wiring Harness.
1. Remove winch from machine (WP
0267).
2. Disconnect winch wiring harness
connector WF-C3 (WP 0018, Fig-
ure 255) from drive-away solenoid
(WP 0018, Figure 258) (WP
0266).
3. Disconnect winch wiring harness
connector WF-C2 (WP 0018, Fig-
ure 254) from free-spool solenoid
(WP 0018, Figure 257) (WP
0266).
4. Disconnect winch wiring harness
connector WF-C5 (WP 0018, Fig-
ure 256) from brake solenoid (WP
0018, Figure 259) (WP 0266).
0023-269