TM 5-2410-240-23-1
0023
Table 2. Blade, Winch, and Ripper Troubleshooting With Codes - Continued.
0023
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2482-05 Winch Drive Away
Test Step 4. Test J813-BK Drive-
Solenoid Current Below Nor- Away Solenoid Return Circuit for
mal - Continued
High Resistance or Open in Plat-
form Wiring Harness.
1. Using digital multimeter (WP
Resistance Less Than 5.0 Ohms -
0283), measure resistance
Replace equipment ECM (WP 0148).
between PL-C2 terminal 59 (WP
Connect platform wiring harness con-
0018, Figure 215) and PL-C33
nector PL-C5 (WP 0018, Figure 218)
terminal 3 (WP 0018, Figure 233).
on ECM J2 (WP 0149).
Connect platform wiring harness con-
nector PL-C4 (WP 0018, Figure 217)
on ECM J1 (WP 0149).
Connect winch solenoid wiring har-
ness connector WC-C2 (WP 0018,
Figure 249) on platform wiring har-
ness connector PL-C33 (WP 0018,
Figure 233) (WP 0137).
Install right rear access cover on
machine (WP 0191).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Replace platform wiring harness (WP
0155).
Connect winch wiring harness con-
nector WF-C1 (WP 0018, Figure 253)
on winch solenoid wiring harness con-
nector WC-C3 (WP 0018, Figure 250)
(WP 0137).
Install rear bottom guards on machine
(WP 0156).
Proceed to step 2.
2. Using MSD (WP 0016), select
Code 2482-05 Active - Repeat trou-
machine control D6K ECM and
bleshooting code from the beginning.
verify 2482-05 is not active.
Code 2482-05 Not Active - Trouble-
shooting complete.
0023-275
