TM 5-2410-241-23-1
0019
Table 2. Engine Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
E190 Engine Overspeed
1. Connect MSD (WP 0016). Select
1. If active codes are present, trou-
Warning
3176C D7 engine ECM and check
bleshoot the applicable code(s)
for Diagnostic Codes or Event
Codes (WP 0013).
2. If no active codes are present,
proceed to step 2.
2. Conditions Which Generate This
Code:
This event code indicates opera-
tor error. No troubleshooting is
required. This is an informational
event code only.
The Engine Electronic Control Module
(ECM) monitors the following:
Engine speed is above 2,700
RPM for more than 0.6 seconds.
Event indicates excessive engine
speed. Event does not represent
a fault with engine speed/timing
sensors or engine ECM.
Engine ECM logs event and a
warning will display on the control
panel.
E272 Inlet Air Restriction
1. Connect MSD (WP 0016). Select
1. If active codes are present, trou-
Warning
3176C D7 engine ECM and check
bleshoot the applicable code(s)
for Diagnostic Codes or Event
Codes (WP 0013).
2. If no active codes are present,
proceed to step 2.
2. Inspect air inlet and exhaust sys-
1. If problem is found, verify correct
tem for damage. Refer to Air Inlet
operation of machine (TM 5-2410-
and Exhaust Inspection
241-10).
2. If air inlet and exhaust system is
OK, proceed to Troubleshooting
Index (WP 0013).
END OF TASK
END OF WORK PACKAGE
0019-95/(96 blank)