TM 5-2410-241-23-1
0020
Table 1. Powertrain Troubleshooting Procedures - Continued.
0020
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
368-2 Autoshift Switch Data
9. Using a digital multimeter (WP
1. If voltage of 12.5 to 13.5 volts is
Erratic, Intermittent, or
0296), measure for voltage
found, replace auto shift switch
Incorrect - Continued
between pins B and C on bi-direc-
(WP 0262). Ensure all harness
tional mode switch connector E-
connectors are reconnected. Ver-
C11 (WP 0018, Figure 50).
ify correct operation of machine
(TM 5-2410-241-10).
2. If voltage of 12.5 to 13.5 volts is
NOT found, proceed to step 10.
10. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
11. Remove left platform access panel
(WP 0207).
12. Disconnect steering control har-
ness connector X-C1 (WP 0018,
Figure 34) from platform harness
connector MA-C14 (WP 0018, Fig-
ure 33).
13. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 14.
pin A on dash harness autoshift
2. If continuity is NOT found, replace
switch connector E-C11 (WP
platform harness (WP 0209).
0018, Figure 50) and pin 14 on
Ensure all harness connectors are
platform harness connector MA-
reconnected. Verify correct opera-
C14 (WP 0018, Figure 33).
tion of machine (TM 5-2410-241-
10).
14. Using a digital multimeter (WP
1. If continuity is found, proceed to
0296), test for continuity between
step 15.
pin B on dash harness autoshift
2. If continuity is NOT found, replace
switch connector E-C11 (WP
platform harness (WP 0209).
0018, Figure 50) and pin 15 on
Ensure all harness connectors are
platform harness connector MA-
reconnected. Verify correct opera-
C14 (WP 0018, Figure 33).
tion of machine (TM 5-2410-241-
10).
15. Using a digital multimeter (WP
1. If continuity is NOT found, proceed
0296), test for continuity between
to step 16.
pin 14 on platform harness con-
2. If continuity is found, replace plat-
nector MA-C14 (WP 0018, Figure
form harness (WP 0209). Ensure
33) and all other pins in platform
all harness connectors are recon-
harness connector MA-C14 (WP
nected. Verify correct operation of
0018, Figure 33).
machine (TM 5-2410-241-10).
0020-56