TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Right Door Windshield
26. Using digital multimeter (WP
1. If continuity is NOT found, replace
Wiper Does Not Operate
0296), test for continuity between
headliner harness (WP 0232).
Properly - Continued
528 PINK right door wiper HIGH
Ensure all harness connectors
supply connector (WP 0018, Fig-
are reconnected. Verify correct
ure 143) and pin 3 on headliner
operation of machine (TM 5-2410-
harness connector HA-C2 (WP
241-10).
0018, Figure 115).
2. If continuity is found, replace right
door wiper switch (WP 0234).
Ensure all harness connectors
are reconnected. Verify correct
operation of machine (TM 5-2410-
241-10).
27. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
28. Disconnect cab harness right
door wiper motor connector H-C4
(WP 0018, Figure 125) from right
door wiper motor (WP 0250).
29. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).
1. If 24 Volts is found, proceed to
30. Using digital multimeter (WP
step 31.
0296), measure for voltage
2. If 24 Volts is NOT found, replace
between pin 6 on cab harness
cab harness (WP 0254). Ensure
right door wiper motor connector
all harness connectors are recon-
H-C4 (WP 0018, Figure 125) and
nected. Verify correct operation of
pin 2 on cab harness right door
machine (TM 5-2410-241-10).
wiper motor connector H-C4 (WP
0018, Figure 125).
31. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-2410-241-10).
32. Connect jumper wire between pin
6 on cab harness right door wiper
motor connector H-C4 (WP 0018,
Figure 125) and pin 3 on cab har-
ness right door wiper motor con-
nector H-C4 (WP 0018, Figure
125).
33. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-2410-241-10).
0022-85