TM 5-2410-241-23-1
0022
Table 1. Cab Troubleshooting Procedures - Continued.
0022
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Right Door Windshield
49. Remove rear wiper motor trim
Wiper Does Not Operate
panel (WP 0229).
Properly - Continued
50. Disconnect headliner harness
connector HA-C2 (WP 0018, Fig-
ure 115) from cab harness con-
nector H-C6 (WP 0018, Figure
114).
51. Using digital multimeter (WP
1.
If continuity is NOT found, replace
0296), test for continuity between
cab harness (WP 0254). Ensure
the following pins on cab harness
all harness connectors are recon-
right door wiper motor connector
nected. Verify correct operation of
H-C4 (WP 0018, Figure 125) and
machine (TM 5-2410-241-10).
pins on cab harness connector H- 2.
If continuity is found, proceed to
C6 (WP 0018, Figure 114).
step 52.
a. Between pin 4 on H-C4 (WP
0018, Figure 125) and pin 8
on H-C6 (WP 0018, Figure
114).
b. Between pin 5 on H-C4 (WP
0018, Figure 125) and pin 3
on H-C6 (WP 0018, Figure
114).
c.
Between pin 3 on H-C4 (WP
0018, Figure 125) and pin 7
on H-C6 (WP 0018, Figure
114).
52. Disconnect 528 PINK right door
wiper HIGH supply connector
(WP 0018, Figure 143) from right
door wiper switch.
53. Disconnect 527 GREEN right
door wiper LOW supply connector
(WP 0018, Figure 142) from Right
Door wiper switch.
54. Disconnect 526 YELLOW right
door wiper PARK supply connec-
tor (WP 0018, Figure 141) from
Right Door wiper switch.
0022-88