TM 5-2410-241-23-3
0198
CLEANING AND INSPECTION
000198
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0295).
END OF TASK
INSTALLATION
000198
Lubricating/hydraulic oils used in performance of maintenance can be very slippery.
Immediately wipe up any spills. Failure to follow this warning may result in injury to
personnel.
N OT E
Install tubes and fittings as noted during removal.
It may be necessary to remove or loos n other hoses to gain access to bolts.
e
Install hoses through engine compartment into cab.
1. Remove caps and install two new O-rings (Figure 10, Item 3) on hoses (Figure 10, Item 4).
2. Connect two hoses (Figure 10, Item 4) to control valve (Figure 10, Item 2).
3. Install two flanges (Figure 10, Item 1), eight bolts (Figure 10, Item 5), and washers (Figure 10, Item 6) on two
hoses (Figure 10, Item 4).
4. Install right cover plate (Figure 11, Item 2), 10 washers (Figure 11, Item 4), and bolts (Figure 11, Item 3) on
console (Figure 11, Item 1).
Figure 11. Right Panel.
0198
