TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0004-05 Cylinder #4 Injector Current
2. Remove jumper wire from E-
Below Normal Continued
C13 (WP 0018, Figure 112)
harness connector terminal 1
and terminal 2.
3. Using digital multimeter
Resistance Less Than 5.0 Ohms
(WP 0283), test for resistance
- Fuel injector is faulty. Replace
between terminal 1 and termi-
fuel injector #4 (WP 0077).
nal 2 at G-C1 (WP 0018,
Connect E-C13 (WP 0018,
Figure 173) harness connec-
Figure 112) to G-C1 (WP 0018,
tor.
Figure 173) at the valve cover
base.
Verify proper operation of machine
(TM 5-2410-240-10).
Resistance 5.0 Ohms or Greater
- Proceed to step 4.
4. Remove valve cover
(WP 0104).
5. Disconnect forward fuel injec-
tor harness terminal G-T33
and terminal G-T44 (WP 0018,
Figure 270) from fuel injector
#4.
6. Install a jumper wire between
terminal G-T33 and terminal
G-T44 (WP 0018, Figure 270)
of forward fuel injector har-
ness.
7. Using digital multimeter
Continuity - Fuel injector is faulty.
(WP 0283), test for continuity
Replace fuel injector #4 (WP
between terminal 1 and termi-
0077).
nal 2 at G-C1 (WP 0018,
Remove jumper wire from termi-
Figure 173) harness connec-
nal G-T33 and terminal G-T44
tor.
(WP 0018, Figure 270).
Connect E-C13 (WP 0018,
Figure 112) to G-C1 (WP 0018,
Figure 173) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Replace forward
fuel injector harness (WP 0104).
Verify proper operation of machine
(TM 5-2410-240-10).
0019-35
