TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0005-02 Cylinder #5 Injector Erratic,
2. Start and run engine to normal
Intermittent, or Incorrect Codel
operating temperature (TM 5-
Continued
2410-240-10).
3. At MSD, check for active diag- 0005-02 Diagnostic Code Active
- Proceed to Test Step 3.
No Active Diagnostic Codes -
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 3: Check ECM Flash
Files.
Flash Files Bad - Replace ECM
Verify correct engine ECM flash
operation of machine (TM 5-2410-
240-10).
Flash Files Good - Replace
engine ECM (WP 0049). Verify
proper operation of machine
(TM 5-2410-240-10).
0005-05 Cylinder #5 Injector Current
WARN I N G
Below Normal
Electrical shock hazard. Electronic unit injector system uses 67-
73 Volts. Failure to follow this warning may result in injury to per-
sonnel.
Test Step 1: Test Fuel Injector
and Engine Control Wiring Har-
nesses.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
Select engine ECM C6.6 D6K.
2. Start engine or attempt to start
engine (TM 5-2410-240-10).