TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0005-05 Cylinder #5 Injector Current
4. Remove valve cover
Below Normal Continued
(WP 0104).
5. Disconnect forward fuel injec-
tor harness terminal F-T11
and terminal F-T22 (WP 0018,
Figure 271) from fuel injector
#5.
6. Install jumper wire between
terminal F-T11 and terminal F-
T22 (WP 0018, Figure 271) of
forward fuel injector harness.
7. Using digital multimeter
Continuity - Fuel injector is faulty.
(WP 0283), test for continuity
Replace fuel injector #5
between terminal 3 and termi-
(WP 0077).
nal 4 at F-C1 (WP 0018,
Remove jumper wire from termi-
Figure 146) harness connec-
nal F-T11 and terminal F-T22
tor.
(WP 0018, Figure 271).
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Replace forward
fuel injector harness (WP 0104).
Verify proper operation of machine
(TM 5-2410-240-10).
0005-06 Cylinder #5 Injector Current
WARN I N G
Above Normal
Electrical shock hazard. Electronic unit injector system uses 67-
73 Volts. Failure to follow this warning may result in injury to per-
sonnel.
Test Step 1: Test Fuel Injector
and Engine Control Wiring Har-
nesses.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in the circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct the problem and verify diagnostic
code is active before performing this procedure.
Tag wiring harnesses to aid installation.