TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0005-05 Cylinder #5 Injector Current
3. At MSD, check if all three
0001-05, 0002-05, and 0003-05
Below Normal Continued
diagnostic codes: 0001-05,
Diagnostic Codes are Active -
0002-05, and 0003-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
4. At MSD, check if all three
0004-05, 0005-05, and 0006-05
diagnostic codes: 0004-05,
Diagnostic Codes are Active -
0005-05, and 0006-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
0005-05 Only Active - Proceed to
Test Step 2.
Test Step 2: Isolate Problem
with Engine Control Wiring Har-
ness.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Disconnect E-C14 (WP 0018,
Figure 113) harness connector
from F-C1 (WP 0018, Figure
146) at the valve cover base.
3. Install jumper wire at E-C14
(WP 0018, Figure 113) har-
ness connector terminal 3 and
terminal 4.
4. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds in order for diagnostic codes to become
active.
5. Start engine or attempt to start
engine (TM 5-2410-240-10).
6. At MSD, check that diagnostic
0005-06 Becomes Active - ECM
code 0005-06 is active
and engine control wiring harness
are OK, proceed to Test Step 3.
0005-05 Remains Active - Pro-
ceed to step 7.
7. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
0019-41
