TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0004-06 Cylinder #4 Injector Current
3. Turn ignition switch to the ON
Above Normal Continued
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Other fuel injector diagnostic codes may also set, ignore those
codes during this procedure.
4. Start engine or attempt to start
engine (TM 5-2410-240-10).
5. At MSD, check that diagnostic
0004-05 Becomes Active - ECM
code 0004-05 is active
and harness are OK, proceed to
Test Step 3.
0004-06 Remains Active - Pro-
ceed to step 6.
6. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
7. Disconnect ECM harness con-
nector E-C1 (WP 0018,
Figure 102) from engine ECM
J2.
8. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1
(WP 0052). Verify proper operation
(WP 0018, Figure 102) termi-
of machine (TM 5-2410-240-10).
nal 64 and all other terminals
No Continuity - Proceed to step 9.
in engine ECM harness con-
nector E-C1 (WP 0018,
Figure 102).
9. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1
(WP 0052). Verify proper operation
(WP 0018, Figure 102) termi-
of machine (TM 5-2410-240-10).
nal 64 and ground.
No Continuity - ECM is faulty,
Replace engine ECM (WP 0049).
Connect E-C13 (WP 0018,
Figure 112) to G-C1 (WP 0018,
Figure 173) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
0019-37