TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0005-05 Cylinder #5 Injector Current
8. Leave jumper wire at E-C14
Below Normal Continued
(WP 0018, Figure 113) har-
ness connector between ter-
minal 3 and terminal 4 in
place.
9. Disconnect ECM harness con-
nector E-C1 (WP 0018,
Figure 102) from engine ECM
J2.
10. Using digital multimeter
Continuity - ECM faulty. Replace
(WP 0283), test for continuity
engine ECM (WP 0049).
at engine ECM harness con-
Remove jumper wire from E-C14
nector E-C1 (WP 0018,
(WP 0018, Figure 113) terminal 3
Figure 102) between
and terminal 4.
terminal 7 and terminal 63.
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at the valve cover
base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
Test Step 3: Test Forward Fuel
Injector Harness.
1. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
2. Remove jumper wire from E-
C14 (WP 0018, Figure 113)
harness connector terminal 3
and terminal 4.
3. Using digital multimeter
Resistance Less Than 5.0 Ohms
(WP 0283), test for resistance
- Fuel injector is faulty. Replace
between terminal 3 and termi-
fuel injector #5 (WP 0077).
nal 4 at F-C1 (WP 0018,
Connect E-C14 (WP 0018,
Figure 146) harness connec-
Figure 113) to F-C1 (WP 0018,
tor.
Figure 146) at the valve cover
base.
Verify proper operation of machine
(TM 5-2410-240-10).
Resistance 5.0 Ohms or Greater
- Proceed to step 4.
0019-42