TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0005-06 Cylinder #5 Injector Current
1. Connect MSD (WP 0016).
Above Normal Continued
Select engine ECM C6.6 D6K.
2. Start engine or attempt to start
engine (TM 5-2410-240-10).
3. At MSD, check if all three
0001-05, 0002-05, and 0003-05
diagnostic codes 0001-05,
Diagnostic Codes are Active -
0002-05, and 0003-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
4. At MSD, check if all three
0004-05, 0005-05, and 0006-05
diagnostic codes 0004-05,
Diagnostic Codes are Active -
0005-05, and 0006-05 are
Replace engine ECM (WP 0049).
active (WP 0016).
Verify proper operation of machine
(TM 5-2410-240-10).
0005-06 Only Active - Proceed to
Test Step 2.
Test Step 2: Isolate problem
with engine control wiring har-
ness.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Disconnect E-C14 (WP 0018,
Figure 113) harness connector
from F-C1 (WP 0018,
Figure 146) at valve cover
base.
3. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds in order for diagnostic codes to become
active.
Other fuel injector diagnostic codes may also set, ignore those
codes during this procedure.
4. Start engine or attempt to start
engine (TM 5-2410-240-10).
5. At MSD, check that diagnostic
0005-05 Becomes Active - ECM
code 0005-05 is active
and harness are OK, proceed to
Test Step 3.
0005-06 Remains Active - Pro-
ceed to step 6.
6. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
0019-44
