TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
0006-05 Cylinder #6 Injector Current
Below Normal Continued
Wait at least 30 seconds for diagnostic codes to become active.
5. Start engine or attempt to start
engine (TM 5-2410-240-10).
6. At MSD, check that diagnostic
0006-06 Becomes Active - ECM
code 0006-06 is active (WP
and engine control wiring harness
are OK, proceed to Test Step 3.
0006-05 Remains Active - Pro-
ceed to step 7.
7. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
8. Leave jumper wire at E-C14
(WP 0018, Figure 113) har-
ness connector between ter-
minal 1 and terminal 2 in
place.
9. Disconnect ECM harness con-
nector E-C1 (WP 0018, Figure
102) from engine ECM J2.
10. Using digital multimeter
Continuity - ECM faulty. Replace
(WP 0283), test for continuity
engine ECM (WP 0049).
at engine ECM harness con-
Remove jumper wire from E-C14
nector E-C1 (WP 0018,
(WP 0018, Figure 113) terminal 1
Figure 102) between terminal
and terminal 2.
6 and terminal 62.
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
Test Step 3: Test Forward Fuel
Injector Harness.
1. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
2. Remove jumper wire from E-
C14 (WP 0018, Figure 113)
harness connector terminal 1
and terminal 2.
0019-49