TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0006-06 Cylinder #6 Injector Current
3. Turn ignition switch to ON
Above Normal Continued
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
Other fuel injector diagnostic codes may also set, ignore those
codes during this procedure.
4. Start engine or attempt to start
engine (TM 5-2410-240-10).
5. At MSD, check that diagnostic
0006-05 Becomes Active - ECM
code 0006-05 is active
and harness are OK, proceed to
Test Step 3.
0006-06 Remains Active - Pro-
ceed to step 6.
6. Turn ignition and battery dis-
connect switch to OFF posi-
tion (TM 5-2410-240-10).
7. Disconnect ECM harness con-
nector E-C1 (WP 0018, Figure
102) from engine ECM J2.
8. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1 (WP
(WP 0052). Verify proper operation
0018, Figure 102) terminal 62
of machine (TM 5-2410-240-10).
and all other terminals in
No Continuity - Proceed to step 9.
engine ECM harness connec-
tor E-C1 (WP 0018,
Figure 102).
9. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is shorted. Replace
between engine ECM har-
engine control wiring harness
ness connector E-C1
(WP 0052). Verify proper operation
(WP 0018, Figure 102) termi-
of machine (TM 5-2410-240-10).
nal 62 and ground.
No Continuity - ECM is faulty,
replace engine ECM (WP 0049).
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
0019-52