TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0006-06 Cylinder #6 Injector Current
7. Using digital multimeter
Continuity - Forward fuel injector
Above Normal Continued
(WP 0283), test for continuity
harness is shorted. Replace for-
between F-C1 (WP 0018,
ward fuel injector harness
Figure 146) harness connec-
(WP 0104). Verify proper operation
tor terminal 2 and ground.
of machine (TM 5-2410-240-10).
No Continuity - Fuel injector #6 is
faulty. Replace fuel injector #6
(WP 0077).
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
0006-07 Active - Replace fuel
0006-07 Cylinder #6 Injector Not
Connect MSD (WP 0016). Select
injector #6 (WP 0077). Verify
Responding Properly
engine ECM C6.6 D6K. Check for
proper operation of machine
any diagnostic codes (WP 0013).
(TM 5-2410-240-10).
No Active Codes - Problem does
not exist at this time. Resume nor-
mal operation.
0041-03 8 Volt DC Supply Voltage
Test Step 1: Test 8-Volt Supply
Above Normal
Circuit.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in the circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K
and verify 0041-03 is active.
2. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
3. Disconnect E-C4 (WP 0018,
Figure 105) harness connec-
tor from engine speed sensor.
4. Disconnect E-C3 (WP 0018,
Figure 104) harness connec-
tor from speed (injection pump
position) sensor.