TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-03 8 Volt DC Supply Voltage
5. Disconnect E-C1 (WP 0018,
Above Normal - Continued
Figure 102) harness connec-
tor from the engine ECM J2.
6. Disconnect EN-C13
(WP 0018, Figure 130) har-
ness connector from the
engine ECM J1.
7. Using digital multimeter
Continuity - Circuit 996-GN 8-volt
(WP 0283), test for continuity
supply circuit is shorted. Replace
between E-C1 (WP 0018,
engine control wiring harness
Figure 102) terminal 10 and all
(WP 0052). Verify proper operation
other terminals in E-C1
of machine (TM 5-2410-240-10).
(WP 0018, Figure 102).
No Continuity - ECM faulty,
Replace engine ECM (WP 0049).
Connect E-C4 (WP 0018,
Figure 105) to engine speed sen-
sor.
Connect E-C3 (WP 0018,
Figure 104) to speed (injection
pump position) sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
0041-04 8-Volt DC Supply Voltage
Test Step 1: Test 8-Volt Supply
Below Normal
Circuit.
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K
and verify 0041-04 is active.
2. Turn ignition switch to OFF
position (TM 5-2410-240-10).
3. Disconnect E-C4 (WP 0018,
Figure 105) harness connec-
tor from engine speed sensor.
4. Disconnect E-C3 (WP 0018,
Figure 104) harness connec-
tor from speed (injection pump
position) sensor.