TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0100-03 Engine Oil Pressure Sensor
Test Step 1: Test 5-Volt and
Voltage Above Normal
Return Circuit.
N OT E
Always inspect harness connectors that are involved in the
circuit. Poor connections can often be the cause of an electrical
circuit problem. Verify that all connections in circuit are clean and
secure, and connections are in good condition. If a problem with
connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K
and verify 0100-03 is active.
2. Turn ignition switch to OFF
position (TM 5-2410-240-10).
3. Disconnect engine oil pres-
sure sensor E-C5 (WP 0018,
Figure 106) harness connec-
tor.
4. Install jumper wire between
engine oil pressure sensor
harness connector E-C5
(WP 0018, Figure 106) termi-
nal 1 and terminal 2.
5. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
0262-04 Becomes Active -
6. Using MSD (WP 0016), select
Proceed to Test Step 2.
engine ECM C6.6 D6K and
check if diagnostic code 0262-
0262-04 Not Active - Proceed to
04 is active.
Test Step 4.
Test Step 2: Test Signal Circuit.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Remove jumper wire from E-
C5 (WP 0018, Figure 106) ter-
minal 1 and terminal 2.
3. Install jumper wire between
engine oil pressure sensor
harness connector E-C5
(WP 0018, Figure 106) termi-
nal 3 and terminal 2.