TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0100-03 Engine Oil Pressure Sensor
4. Turn ignition switch to ON
Voltage Above Normal Continued
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
0100-03 Remains Active - Pro-
5. Using MSD (WP 0016), select
ceed to Test Step 3.
engine ECM C6.6 D6K, and
check if diagnostic code 0100-
0100-04 Becomes Active - ECM
04 is active.
and signal circuit test OK, sensor
is faulty. Replace engine oil pres-
sure sensor (WP 0053).
Remove jumper wire from E-C5
(WP 0018, Figure 106) terminal 3
and terminal 2.
Connect E-C5 (WP 0018,
Figure 106) to engine oil pressure
sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 3: Test Harness Sig-
nal Circuit.
1. Turn ignition switch and bat-
tery disconnect switch to OFF
position (TM 5-2410-240-10).
2. Leave jumper wire at engine
oil pressure sensor harness
connector E-C5 (WP 0018,
Figure 106) terminal 3 and ter-
minal 2 in place.
3. Disconnect engine ECM har-
ness connector E-C1
(WP 0018, Figure 102) from
engine ECM J2.
0019-59