TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0100-10 Engine Oil Pressure Sensor
6. Install jumper wire between E-
Abnormal Rate of Change Contin-
C5 (WP 0018, Figure 106)
ued
engine oil pressure sensor
harness connector terminal 1
and terminal 3.
7. Using digital multimeter
Continuity - Proceed to Test
(WP 0283), test for continuity
Step 2.
between engine ECM har-
No Continuity - Engine control
ness connector E-C1
wiring harness is open. Replace
(WP 0018, Figure 102) termi-
engine control wiring harness
nal 47 and terminal 56.
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
Test Step 2: Test Harness
Return Circuit.
1. Remove jumper wire from
engine oil pressure sensor
harness connector E-C5
(WP 0018, Figure 106) termi-
nal 1 and terminal 3.
2. Install jumper wire between E-
C5 (WP 0018, Figure 106)
engine oil pressure sensor
harness connector terminal 2
and terminal 3.
3. Using digital multimeter
Continuity - Engine control wiring
(WP 0283), test for continuity
harness is OK. Sensor is faulty.
between engine ECM har-
Replace engine oil pressure sen-
ness connector E-C1
sor (WP 0053).
(WP 0018, Figure 102) termi-
Remove jumper wire from E-C5
nal 39 and terminal 56.
(WP 0018, Figure 106) terminal 2
and terminal 3.
Connect E-C5 (WP 0018,
Figure 106) to engine oil pressure
sensor.
Connect E-C1 (WP 0018,
Figure 102) to engine ECM J2.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052). Verify proper operation
of machine (TM 5-2410-240-10).
0019-63