TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0110-03 Engine Coolant Temperature
6. Using digital multimeter
Continuity - ECM faulty. Replace
Sensor Voltage Above Normal Code
(WP 0283), test for continuity
engine ECM (WP 0049).
Continued
between E-C1 (WP 0018,
Connect E-C8 (WP 0018,
Figure 102) terminal 37 and
Figure 109) to Air Intake Tempera-
E-C8 (WP 0018, Figure 109)
ture sensor.
terminal 2.
Connect E-C10 (WP 0018,
Figure 110) to engine coolant tem-
perature sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052).
Verify proper operation of machine
(TM 5-2410-240-10).
0110-04 Engine Coolant Temperature
Test Step 1: Test Signal Circuit.
Sensor Voltage Below Normal Code
N OT E
Always inspect harness connectors that are involved in circuit.
Poor connections can often be the cause of an electrical circuit
problem. Verify that all connections in the circuit are clean and
secure, and connections are in good condition. If a problem with
a connection is found, correct problem and verify diagnostic code
is active before performing this procedure.
Tag wiring harnesses to aid installation.
1. Connect MSD (WP 0016).
Select engine ECM C6.6 D6K
and verify 0110-04 is active.
2. Turn ignition switch to OFF
position (TM 5-2410-240-10).
3. Disconnect engine coolant
temperature sensor E-C10
(WP 0018, Figure 110) har-
ness connector.
4. Turn ignition switch to ON
position (TM 5-2410-240-10).