TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0110-03 Engine Coolant Temperature
4. Using digital multimeter
Continuity - Engine control wiring
Sensor Voltage Above Normal Code
(WP 0283), test for continuity
harness is shorted. Replace
Continued
between ECM harness con-
engine control wiring harness
nector E-C1 (WP 0018,
(WP 0052). Verify proper operation
Figure 102) terminal 43 and all
of machine (TM 5-2410-240-10).
other terminals in ECM har-
No Continuity - ECM faulty.
ness connector E-C1
Replace engine ECM (WP 0049).
(WP 0018, Figure 102).
Remove jumper wire from E-C10
(WP 0018, Figure 110) terminal 1
and terminal 2.
Connect E-C10 (WP 0018,
Figure 110) to engine coolant tem-
perature sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
Test Step 4: Test Harness
Return Circuit.
1. Turn the ignition switch and
battery disconnect switch to
the OFF position (TM 5-2410-
240-10).
2. Remove jumper wire from
engine coolant temperature
sensor harness connector E-
C10 (WP 0018, Figure 110)
terminal 1 and terminal 2.
3. Disconnect engine ECM har-
ness connector E-C1
(WP 0018, Figure 102) from
engine ECM J2.
4. Disconnect Air Intake Temper-
ature sensor E-C8 (WP 0018,
Figure 109) harness connec-
tor.
5. Using digital multimeter
Continuity - Proceed to step 6.
(WP 0283), test for continuity
No Continuity - Engine control
between E-C1 (WP 0018,
wiring harness is open. Replace
Figure 102) terminal 37 and
engine control wiring harness
E-C10 (WP 0018, Figure 110)
(WP 0052). Verify proper operation
terminal 2.
of machine (TM 5-2410-240-10).
0019-66