TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0041-04 8 Volt DC Supply Voltage
5. Turn ignition switch to ON
Below Normal Continued
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
0041-04 Remains Active -
6. Using MSD (WP 0016), select
Proceed to step 11.
engine ECM C6.6 D6K, and
check if diagnostic code 0041-
0041-04 Becomes Inactive -
04 goes away.
Proceed to step 7.
7. Connect engine speed sensor
to E-C4 (WP 0018,
Figure 105) harness connec-
tor.
8. Using MSD (WP 0016), select
0041-04 Becomes Active -
engine ECM C6.6 D6K, and
Replace engine speed sensor
check if diagnostic code 0041-
(WP 0052).
04 is active.
Connect E-C3 (WP 0018,
Figure 104) to speed (injection
pump position) sensor.
Verify proper operation of machine
(TM 5-2410-240-10).
0041-04 Remains Inactive - Pro-
ceed to step 9.
9. Connect speed (injection
pump position) sensor to E-C3
(WP 0018, Figure 104) har-
ness connector.
0041-04 Becomes Active -
10. Using MSD (WP 0016), select
Replace speed (injection pump
engine ECM C6.6 D6K, and
position) sensor (WP 0076). Verify
check if diagnostic code 0041-
proper operation of machine
04 is active.
(TM 5-2410-240-10).
0041-04 Remains Inactive -
Replace throttle position switch.
Refer to Right Side Console
(WP 0212). Verify proper operation
of machine (TM 5-2410-240-10).
11. Turn the ignition switch and
battery disconnect switch to
OFF position (TM 5-2410-240-
10).
12. Disconnect engine ECM har-
ness connector E-C1
(WP 0018, Figure 102) from
engine ECM J2.
0019-56