TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
0006-05 Cylinder #6 Injector Current
3. Using digital multimeter
Resistance Less Than 5.0 Ohms
Below Normal Continued
(WP 0283), test for resistance
- Fuel injector is faulty. Replace
between terminal 1 and termi-
fuel injector #6 (WP 0077).
nal 2 at F-C1 (WP 0018,
Connect E-C14 (WP 0018,
Figure 146) harness connec-
Figure 113) to F-C1 (WP 0018,
tor.
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
Resistance 5.0 Ohms or Greater
- Proceed to step 4.
4. Remove valve cover
(WP 0104).
5. Disconnect forward fuel injec-
tor harness terminal F-T33
and terminal F-T44 (WP 0018,
Figure 271) from fuel injector
#6.
6. Install jumper wire between
terminal F-T33 and terminal F-
T44 (WP 0018, Figure 271) of
forward fuel injector harness.
7. Using digital multimeter
Continuity - Fuel injector is faulty.
(WP 0283), test for continuity
Replace fuel injector #6
between terminal 1 and termi-
(WP 0077).
nal 2 at F-C1 (WP 0018,
Remove jumper wire from termi-
Figure 146) harness connec-
nal F-T33 and terminal F-T44
tor.
(WP 0018, Figure 271).
Connect E-C14 (WP 0018,
Figure 113) to F-C1 (WP 0018,
Figure 146) at valve cover base.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Replace forward
fuel injector harness (WP 0104).
Verify proper operation of machine
(TM 5-2410-240-10).
0019-50
