TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1785-03 Intake Manifold Pressure
4. Install jumper wire between
Sensor Voltage Above Normal
air (boost) pressure sensor
Continued
harness connector E-C7
(WP 0018, Figure 108) termi-
nal 1 and terminal 2.
5. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
6. Using MSD (WP 0016), select
0262-04 Becomes Active - Pro-
engine ECM C6.6 D6K and
ceed to Test Step 2.
check if diagnostic code 0262-
0262-04 Not Active - Proceed to
04 is active.
Test Step 4.
Test Step 2: Test Signal Circuit.
1. Turn ignition switch to OFF
position (TM 5-2410-240-10).
2. Remove jumper wire between
air (boost) pressure sensor
harness connector E-C7
(WP 0018, Figure 108) termi-
nal 1 and terminal 2.
3. Install jumper wire between air
(boost) pressure sensor har-
ness connector E-C7
(WP 0018, Figure 108) termi-
nal 3 and terminal 2.
4. Turn ignition switch to ON
position (TM 5-2410-240-10).
N OT E
Wait at least 30 seconds for diagnostic codes to become active.
0019-108