TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
E1044-2 High Intake Manifold Pres-
1. Inspect wastegate solenoid
Wastegate OK - Proceed to
sure
lines for damage (WP 0028).
step 2.
Damage Found - Replace turbo-
charger lines (WP 0080). Verify
proper operation of machine
(TM 5-2410-240-10).
2. Perform Wastegate Solenoid
Wastegate Solenoid OK -
Replace turbocharger (WP 0079).
Test (WP 0028).
Verify proper operation of machine
(TM 5-2410-240-10).
Blockage/Restriction Found -
E1045-2 Low Intake Manifold Pres-
1. Inspect air intake system for
Remove blockages/restrictions
sure
blockage or restrictions. Refer
(WP 0041). Verify proper operation
to Air Inlet and Exhaust Sys-
of machine (TM 5-2410-240-10).
tem Inspection (WP 0028).
Air intake OK - Proceed to step 2.
2. Inspect air intake system for
Damage or Leakage Found -
leakage or damage. Refer to
Replace damaged lines or hoses
Air Cleaner, Air Inlet, and
(WP 0041). Verify proper operation
Check Valve Inspection
of machine (TM 5-2410-240-10).
Air intake OK - Proceed to step 3.
3. Inspect for exhaust leaks
Leakage Found Between Mani-
between exhaust manifold and
fold and Engine - Replace
engine and between exhaust
exhaust manifold and exhaust
manifold and turbo. Refer to
manifold gasket (WP 0081). Verify
Exhaust System Inspection
proper operation of machine
(TM 5-2410-240-10).
Leakage Found Between Mani-
fold and Turbo - Replace turbo-
charger to manifold gasket
(WP 0079). Verify proper operation
of machine (TM 5-2410-240-10).
No Leakage Found - Proceed to
step 4.
4. If air intake system is not
Replace inlet manifold and/or gas-
restricted and no exhaust
ket (WP 0088). Verify proper oper-
leaks are found, inlet manifold
ation of machine (TM 5-2410-240-
is leaking.
10).
END OF WORK PACKAGE
0019-129/(130 blank)