TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
E172-2 Event Codes High Air Filter
2. Inspect air inlet system for
Air Inlet System is Blocked or
Restriction Code - Warning
damage, blockage, and clean- Dirty - Clean and remove block-
Continued
liness (WP 0028).
age from air inlet system compo-
nents (WP 0028). Verify proper
operation of machine (TM 5-2410-
240-10).
E194-2 High Exhaust Temperature
1. Using Messenger (WP 0015),
E194-2 Present - Proceed to
Code - Derate
verify presence of event code
step 2.
E194-2.
2. Verify if engine was operating
Yes - No action required.
under heavy load when code
No - Proceed to step 3.
occurred.
3. Verify if engine was operating
Yes - No action required.
at high altitude when code
No - Proceed to step 4.
occurred.
4. Inspect turbocharger
Turbocharger Components
Damaged or Restricted - Replace
turbocharger (WP 0079) or clear
restriction (WP 0028). Verify
proper operation of machine
(TM 5-2410-240-10).
Turbocharger OK - Check for
leaks in the engine oil cooler
assembly. Refer to Engine Oil
Cooler Inspection (WP 0027).
E360-1 Low Engine Oil Pressure -
1. Using Messenger (WP 0015),
E360-1 Present - Proceed to
Warning
verify presence of event code
step 2.
E360-1.
2. Check oil level in engine
Oil Low - Add oil as needed
(WP 0085).
(WP 0085).
Oil Level OK - Proceed to step 3.
3. Check actual engine oil pres-
Oil Pressure Low - Replace
sure with a calibrated test
engine oil pump (WP 0100). Per-
gauge, refer to Engine Oil
form engine oil pressure test again
Pressure - Test (WP 0025).
(WP 0025). If oil pressure remains
low, replace engine (WP 0051).
Oil Pressure OK - Replace oil
pressure sensor (WP 0053). Ver-
ify proper operation of machine
(TM 5-2410-240-10).