TM 5-2410-240-23-1
0019
Table 2. Engine Troubleshooting with Codes - Continued.
0019
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2417-05 Ether Injection Control Sole- 5. Using a digital multimeter (WP
Continuity - ECM faulty. Replace
noid Current Below Normal Code
0283), test for continuity
engine ECM (WP 0049).
Continued
between harness connector
Remove jumper wire from EN-C20
EN-C13 (WP 0018, Figure
(WP 0018, Figure 136) terminal 1
130) from engine ECM J1 ter-
and terminal 2.
minal 25 and 29.
Connect EN-C20 (WP 0018,
Figure 136) to ether valve sole-
noid.
Connect EN-C13 (WP 0018,
Figure 130) to engine ECM J1.
Verify proper operation of machine
(TM 5-2410-240-10).
No Continuity - Engine control
wiring harness is open. Replace
engine control wiring harness
(WP 0052).
Verify proper operation of machine
(TM 5-2410-240-10).
2417-06 Ether Injection Control Sole-
WARN I N G
noid Current Above Normal Code
Breathing ether vapors or repeaed contact of ether with skin can
t
cause personal injury. Use ether only in well-ventilated areas.
Do not smoke while changing ether cylinders.
Use ether with care to avoid fires.
Do not store replacement ether cylinders in living areas or in
operator's compartment.
Do not store ether cylinders in drect sunlight or at temperatures
i
above 120F (49C).
Discard ether cylinders in a safe place. Do not puncture or burn
ether cylinders.
Keep ether cylinders out of reach of unauthorized personnel.
Be sure brakes are applied and all controls are in HOLD or
NEUTRAL position when starting engine.
Failure to follow these warningsmay result in injury to personnel.